home register FAQ memberlist calendar

Go Back   Turbobricks Forums > Mechanical > maintenance & nonperformance

Reply
 
Thread Tools Display Modes
Old 12-29-2017, 05:42 PM   #1
PCH
Board Member
 
Join Date: Oct 2008
Location: SoCal
Default Downpipe to bellhousing clamp

Just did the exhaust manifold gaskets on 940 Turbo - one of the things I am not too sure about it the orientation of the header pipe clamp. The angled tabs were very difficult to align- may be I didn't install it right back when I got it. One tab has the round hole and other is slotted. I image the round goes on the bellhousing stud first and then the slotted side is tightened with the nut? Any help please...

PCH is offline   Reply With Quote
Old 12-29-2017, 08:55 PM   #2
dl242gt
Can play the blues
 
dl242gt's Avatar
 
Join Date: Jun 2002
Location: S NJ, a suburb of Phila.
Default

Are the exhaust clamps and header pipe still loose? That is when to put on something like this clamp. Your description seems fine to me. The slot is to give you some slack so you can put things together. Make sure you use a lock washer or a locking nut so that won't vibrate loose.
__________________
Dave,
1982 242 turbo. 339k miles. Lots of good changes.
1993 245 Classic, 415k miles, enem V15. 5spd. IPD bars and chassis braces. Simons sport exhaust from Scandix. chipped ezk. Been a good road warrior.
dl242gt is offline   Reply With Quote
Old 12-30-2017, 06:31 PM   #3
PCH
Board Member
 
Join Date: Oct 2008
Location: SoCal
Default

Thanks. Yes, the connection at the turbo was loose, the trans bracket and the cat ware unbolted. I'll probably order a new clamp because i had to straighten the tabs on mine and now not sure about overall alignment/stress on the exhaust hardware.
I think I was expecting the clamp to close completely when tightened but from the picture it looks like the little bend on one of the tabs acts as a stop so there will be a gap left.
PCH is offline   Reply With Quote
Old 12-30-2017, 08:38 PM   #4
DET17
Reformed SAABaholic
 
Join Date: Nov 2009
Location: NW Georgia
Default

I've got a stocker 9 series DP band clamp on my workbench.... it is NOT square at the ends of the hoop. Both of the perpendicular ears are slightly rotated from being square. The stock DP can't be truly running vertically, the reason for the slight rotation of the ends. For sure, use a metal locknut on the stud to keep it tight.
__________________
Project "cheap thrills" build thread: http://forums.turbobricks.com/showth...67#post4211467

Feedback thread: http://forums.turbobricks.com/showthread.php?t=198746
DET17 is online now   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -4. The time now is 08:43 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2018, vBulletin Solutions Inc.