doucheNozzle
Newbie
- Joined
- Feb 26, 2009
- Location
- The Pitt, 15147
Hey nice camber plates.
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
what are you doing with the intake?
Tom, stunning.
Seriously killer build you got going. The attention to detail is amazing!
I'll be running a modified b21f intake manifold with a 960 3" throttle body and one of nathan's fuel rails. It should be showing up any day now.
If that Getrag don't leak please tell me how you achieved that miracle!!!
Oh! I'm not quite sure what I'll end up doing for the intake yet.
I had been thinking an S-bend pipe with a cone filter placed near the headlight, but now it seems that's where the intercooler hot side pipe will be.
I'll figure that out once I get some piping ordered in and I can play around with it.
That's what I was looking at as well. I had thought about punching through down into that area in front of the wheel well. I bought an NA car where the PO made a baffled sheet metal airbox down there that was really slick, but I'm not sure I like the idea of the filter being that low. I think I'm going to end up just sticking mine over into the corner for now, and maybe I'll make a little airbox around it with some flow from down low so the IC pipe doesn't heat soak it so bad.
Aluminum pipe is not cheap!
Did you pick up the strut brace from Brian?
Looks really really really good. Bummed you got the shell, but I love what you're doing. Out of my league. Keep it up!!