• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

740 Wiring V90 tailgate handle plate lights?

maxman142001

I like turtles
Joined
Jun 2, 2003
Location
Phoenix, AZ
SANY0243.jpg


So the tailgate handle i installed only has one connector on it for the license plate lights....and when I have the lights on only one(drivers side) lights up...anyone know how to get both of them to work right?
 
I know it's simple, but just piggyback from the operating one to the non-operating one. Low amp draw so you're not going to burn something up.
 
yes, but there is only one physical connector on the latch and 2 connectors on the inside wirings. On the original latch each light had a separate connector. Just want to see how everyone connected theirs since this is almost bolt in.
 
It may be "bolt-in" mechanically, but is it "plug-in" electrically?

You want 'em working? Get 'em working!:)
 
Both tag bulbs are powered by the single connector- did you check the bulb on the right side?
 
Back
Top