• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

No Rpm Signal on new Megasquirt instal

The jumpers that cwdodson88 identified in post #7 must be soldered in place.

I don't know how good the instructions are that are provided by DIY. You might want to check out the Megamanual build guide for the Megasquirt V3 board since you seem to be struggling with some pretty basic stuff.

http://www.megamanual.com/ms2/V3assemble.htm

Section 50 covers the set up of the board for use with Hall tach sensors.
 
The board was tested using a stim, hall input works great, if the sensor had a built in pullup. Pullup and some accessories are on their way. They should arrive tomorrow or Saturday. Op- let me know when you get them if there are any questions with what and where they go.
 
142 guy said:
The jumpers that cwdodson88 identified in post #7 must be soldered in place.

I don't know how good the instructions are that are provided by DIY. You might want to check out the Megamanual build guide for the Megasquirt V3 board since you seem to be struggling with some pretty basic stuff.

http://www.megamanual.com/ms2/V3assemble.htm

Section 50 covers the set up of the board for use with Hall tach sensors.
Click to expand...

That is the story of my life struggle with the basics lol, yeah that manual it actually really helpful never thought to look at it before because I am just so smart lol
 
I'm not super fond of the mega manuals layout, I like the msextra manuals mostly because they're way more updated and people on msextra forums can follow what you're doing. And you can skip to what you need faster. Not saying that the mega manual isn't necessary. It's totally worth the time to read and understand.
 
You must log in or register to reply here.
Back
Top