• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

Hydraulic Clutch MC thread size?

Pillow

Sleazebag 7-9 Owner
Joined
Dec 19, 2015
Location
NoVA
Hopefully easy question that has been eluding me. I figure someone else has run into the situation I am in for hydraulic clutch lines.

What is the thread size/pitch for the 7/9 Turbo clutch master cylinder outlet?

I need to run 4AN line from the clutch master cylinder to TO bearing and nothing I have on hand fits the Volvo clutch master cylinder.

Thanks!
 
Thank You!!! I was stuck between the M10 and M12 debate and the only reference I could find was from Dave B's site which was for a 260 setup and not 7/9.

I ordered this: https://www.ebay.com/itm/1-Steel-Ba...763842?hash=item1a26e61a02:g:9UMAAOSwdIFX1ziF
Steel Banjo Bolt Fittings M12 x 1.0 (Metric 12mm) to 4AN -4 AN4

I chose a banjo to get the 90 degree angle as there is not much space to spare with the shock tower.

Once fitted, I will report back.
 
Did this work out?

Thank You!!! I was stuck between the M10 and M12 debate and the only reference I could find was from Dave B's site which was for a 260 setup and not 7/9.

I ordered this: https://www.ebay.com/itm/1-Steel-Ba...763842?hash=item1a26e61a02:g:9UMAAOSwdIFX1ziF
Steel Banjo Bolt Fittings M12 x 1.0 (Metric 12mm) to 4AN -4 AN4

I chose a banjo to get the 90 degree angle as there is not much space to spare with the shock tower.

Once fitted, I will report back.
 
Yes, in mock up it fits like a glove. But it is still a work in progress. Bear with my slowness. :)
 
Back
Top