home register FAQ memberlist calendar

Go Back   Turbobricks Forums > Mechanical > maintenance & nonperformance

Reply
 
Thread Tools Display Modes
Old 01-07-2019, 03:35 PM   #1
Blue42
Board Member
 
Blue42's Avatar
 
Join Date: Oct 2009
Location: Oregon coast
Default b21ft crankshaft removal

Im tearing down my b1ft and am having trouble removing the crank shaft. All the main bearings and rod bearings have been removed, but the crank still wont pop out. What stupid thing am i missing?
Blue42 is offline   Reply With Quote
Old 01-07-2019, 08:13 PM   #2
bobxyz
Board Member
 
bobxyz's Avatar
 
Join Date: Aug 2014
Location: Boulder, Colorado
Default

There shouldn't be any trick to it. Remove the stuff on the ends (seal retainer plates), remove the oil pump, the rod caps and main caps. Rotate just a bit to free up the top half of the rods. If you're OCD, put some scrap rubber tubing on the rod bolts to prevent them from scratching the cylinders.

The thrust bearing may still have a tight fit if it's an automatic. This means that you need to lift straight up or else it will bind. You could lift the other end of the crank just a tiny bit to free up the oil suction on the main bearings, then set it back down to level before lifting the whole crank out. It weighs ~45 pounds, so it takes some muscle.

The engine reconditioning greenbooks are still available here:
http://volvowiringdiagrams.com/?dir=...gine%201975-85
__________________
'85 245glt aw71 k-jet -> lh2.4
bobxyz is offline   Reply With Quote
Old 01-07-2019, 08:39 PM   #3
hiperfauto
Board Member
 
hiperfauto's Avatar
 
Join Date: Nov 2011
Location: So Cal
Default

Until vlvman gets the website back up, use the Internet Archive (aka Wayback Machine) to view the files.

https://web.archive.org/web/20160623...gine%201975-85
hiperfauto is online now   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -4. The time now is 04:19 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.