home register FAQ memberlist calendar

Go Back   Turbobricks Forums > Mechanical > projects & restorations

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 02-12-2018, 04:22 PM   #36
Funkee
Board Member
 
Funkee's Avatar
 
Join Date: Feb 2010
Location: Netherlands
Default

Made brackets for the engine mounts. I ordered some cheap rubber mounts (both pass side) from Rockauto, I'll eventually go with diesel or poly.
I'll make some solid ones first to be sure of absolute correct fitment.
I'll also add a torque arm, still gotta figure out where.

Machined recesses to access the bolts, and for water drainage.






Welded in a tube for steering shaft clearance. I bought a power rack a while ago which is a lot sleaker than the manual rack, so it will clear easily.




Pizza and chocolate milk is a man's shop fuel right?




The passenger side is going to be welded (now just spotted for fitment), drivers side is bolted onto the original boltholes (even used the studs I pressed out of the old mounts )




Made plates for the engine, hope to make the engine fit later this or next week.

Funkee is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -4. The time now is 01:41 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2018, vBulletin Solutions Inc.