mschultz373
Member
- Joined
- Mar 11, 2020
- Location
- dirty coast
i'm trying to install the Volvo updated part for Chrysler ICU harness terminal pins. they look like this:
<a href="https://ibb.co/3NP0jzT"><img src="https://i.ibb.co/cFsNZLy/volvo-sleeves.jpg" alt="volvo-sleeves" border="0"></a>
i'm wondering 1) the orientation on the pins should the open, wider portion towards the control unit?
2) if anyone has done this before and if so, what technique to use? It was already a huge PITA getting the old conductive sleeves off, and now these ones don't seem to want to fit onto the pins short of using a drift and a hammer.
thanks for any advice.
<a href="https://ibb.co/3NP0jzT"><img src="https://i.ibb.co/cFsNZLy/volvo-sleeves.jpg" alt="volvo-sleeves" border="0"></a>
i'm wondering 1) the orientation on the pins should the open, wider portion towards the control unit?
2) if anyone has done this before and if so, what technique to use? It was already a huge PITA getting the old conductive sleeves off, and now these ones don't seem to want to fit onto the pins short of using a drift and a hammer.
thanks for any advice.