boosted12a
weapon of mass detonation
- Joined
- Nov 14, 2002
- Location
- gloucester Va
hot dog!
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
Looking good guys. I should have the group-buy on the new-and-improved surface mount boards up within a few short weeks, so stay tuned!
Looking good guys. I should have the group-buy on the new-and-improved surface mount boards up within a few short weeks, so stay tuned!
Using a Miata 1.6l wasted spark ignition module,
Looking good guys. I should have the group-buy on the new-and-improved surface mount boards up within a few short weeks, so stay tuned!
Sounds great. Is that the Mazda thingamajig in the lower right of the photo?
Yes, J702T misubishi
OC1 Output coil bank 1 (to 1-4 side of your coils)
IB1 Ignition bank 1 (from buchka spark 1-4
VB Voltage Battery 12+ switched
TAC Tacho output straight to your 240 tach if miata unit, IF dsm unit, wire in a 12+ pullup wire with 1k ohm resistor tied into tach line)
IGR 12+ passthrough (unused)
GND Self explanitory
IB2 Ignition input 2 (to 2-3 side of your coils)
OC2 Output coil 2 (from buchka spark 1-4)
shouldnt OC2 go to (buchka spark 2-3) ?
and how about you tell what color wire?
Whatfer Ben?
look at the picture bro, the labels and corresponding wires are directly adjacent to each other.