leslie_s
New member
- Joined
- Dec 2, 2008
- Location
- Saint Joseph, MI
i have a 12" hayden slim fan that pushes 800cfm, is that gonna be good enough, if i take off my clutch fan?
im sure it will. sounds like overkill though....
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
i have a 12" hayden slim fan that pushes 800cfm, is that gonna be good enough, if i take off my clutch fan?
My GLH was slowly over heating at idle with a 1700cfm 14inch Hayden fan, with no shroud. It's fine once the car is moving.
Made a shroud, installed a 2,785 cfm ZFU14S Zirgo fan. Issue is completely gone.
Stock 940/960/850 pulls even more air than my ZFU14S fan, and if it is good enough for a 940/960/850, it's good enough for a 240, (with a shroud).
You don't need a fusible link with the fan. There isn't one on the stock 940, 960, nor 850. Just connect the red wires to 12v, and black to neg. You ground the two little wires to either get high speed or low speed. You can either ground the switch or run a relay to make the fan work. Or get an adjustable thermostat for $20 and have the thermostat do the turning on/off for you.