Mbeas96
Member
- Joined
- Aug 7, 2017
- Location
- Charleston
I guess my thinking on how much fuel it really takes for this turbo at 20psi is a little off. I'll just explain my thoughts on why it was reading so rich...
Knocking during onset because of lack of fuel/not enough at that rpm. Because I have sbabbs "turbo+" chip I am thinking the onset issue should be resolved.
For the next 2k rpm it pulls great, so no problems at that rpm range.
After 4k rpm, I was thinking that knock is happening, not from hearing it, but from the AFRs diving below 10 and the power lessens. And with knock enrichment it pulls timing, right? So I would definitely feel a sudden loss of power.
I'll have to swap back FPRs and let it learn before I can say what it does while slowly rolling into boost.
I haven't pulled the plugs since I put them in about 5k miles ago...
For the maf, this is my 3rd in 2 years and all of them acted the same, but the wire inside the tube broke on the first 2.
Now really though. What do I have to do to run mid 11s throughout the whole pull? I mentioned maybe I should look into an ostrich to better tune lh to my setup.
I *think* I remember reading it's basically essential to "pull" fuel out of lh on the top end. As well as smooth the map going into boost.
Knocking during onset because of lack of fuel/not enough at that rpm. Because I have sbabbs "turbo+" chip I am thinking the onset issue should be resolved.
For the next 2k rpm it pulls great, so no problems at that rpm range.
After 4k rpm, I was thinking that knock is happening, not from hearing it, but from the AFRs diving below 10 and the power lessens. And with knock enrichment it pulls timing, right? So I would definitely feel a sudden loss of power.
I'll have to swap back FPRs and let it learn before I can say what it does while slowly rolling into boost.
I haven't pulled the plugs since I put them in about 5k miles ago...
For the maf, this is my 3rd in 2 years and all of them acted the same, but the wire inside the tube broke on the first 2.
Now really though. What do I have to do to run mid 11s throughout the whole pull? I mentioned maybe I should look into an ostrich to better tune lh to my setup.
I *think* I remember reading it's basically essential to "pull" fuel out of lh on the top end. As well as smooth the map going into boost.