ermit71
Well-known member
- Joined
- Sep 15, 2007
- Location
- Vancouver, BC
Great start of a thread to what should be a fantastic build!
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
Block is almost done at the machine shop. This kicked my butt into getting some new rings.
Contacted CP- the piston manufacturer. Apparently they no longer make the rings for these pistons. They kindly told me the specs, and to contact custom ring manufacturers to have some made. Awesome. They recommended Total Seal.
Guess I'll be contacting them tomorrow.
What CP pistons are these?
yeah if it's not this it's that I suppose.
re: the flywheel mine is still vaporware but it looks like some people have gotten them now. I'm not sure if Josh was going to keep putting them out since it was such a hassle getting this run made.
4.10's should play nicely with the 2.95 box.
Block is almost done at the machine shop. This kicked my butt into getting some new rings.
Contacted CP- the piston manufacturer. Apparently they no longer make the rings for these pistons. They kindly told me the specs, and to contact custom ring manufacturers to have some made. Awesome. They recommended Total Seal.
Guess I'll be contacting them tomorrow.
Thanks John,
That would be greatly appreciated. Should I find the piston spec sheet for you to reference ?
NINJA EDIT- John the job number was 108745 on the piston spec sheet
Jordan
John, did you get a chance to call yet?
Jordan
Yeah and they said supplied stopped doing that set and they would dig a bit. haven't hear back..Kinda sucks big gree donkey dicks cause i have a couple of hundred of those pistons out there in the wide world..Grrrrrrrr!
Waiting for more! I like the wheels.