haltechsupra
New member
- Joined
- Jun 22, 2004
- Location
- Texas
Required fuel is 3.9 ms. As far as the kpa, I am using a holley 5 bar map.
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
low req fuel allows a more finely grained tune (if you need it/want it), as long as you have enough to meet the highest demands. think 255 is the highest value you can use on the ve table.
also, on the siphoning for the alcohol inj, a lot of folks started using solenoids for nozzles installed after the tb that are subject to vacuum. food for thought, wouldn't be much to install some and have them come on with the pump.
What kind of scaling is going on with that VE table?