CRatcliff
Member
- Joined
- Nov 21, 2016
- Location
- Seattle, Washington
Currently running a K-Cam if that's worth anything.
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
The F gasket is .039" compressed.
The B18 rods are notoriously weak. 6 bolt B20 rods are reinforced in the problem area and aren't a problem under 6500 rpm. 8 bolt B20 rods can be swapped for M rods if you don't think they're up to the task.
The F gasket is .039" compressed.
The B18 rods are notoriously weak. 6 bolt B20 rods are reinforced in the problem area and aren't a problem under 6500 rpm. 8 bolt B20 rods can be swapped for M rods if you don't think they're up to the task.
Jumping back to previous topic - any advice on a cam to use? Not sure what the core needed is for the custom one, but I know it's been hell trying to find one.