GreatDaneShane
HBIC
- Joined
- Jul 28, 2007
- Location
- Houston, Texas
So I daily a lifted 84 244, and it eats up tires like a mf. Due to the lift it has more positive camber than it should, even adjusted all the way out. I have a set of spare control arms I'll be extending with some 1/4 inch plate a la travisminchew's thread. My issue is that the sway bar end link mount is right where the third mounting hole will be located if I extend them.
So my question is this- how much freedom do i have to move the mounting point away from its original spot?
Can I use a piece of 1/4 thick angle iron to mount the end link instead of the U shaped piece?
How critical is having both sides of the fastener supported? I'll be using adjustable end links with heim joints on either side.
So my question is this- how much freedom do i have to move the mounting point away from its original spot?
Can I use a piece of 1/4 thick angle iron to mount the end link instead of the U shaped piece?
How critical is having both sides of the fastener supported? I'll be using adjustable end links with heim joints on either side.