• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

MAF rebuild

Used mass air flow sensors are 50/50, for about $60 more you get a remanufactured MAF with a warranty which is more of a wise investment. However this is what I have learned with these MAF. On top of the sensor has bosch on it all they did was fix whatever chip or solder joint and send it out to be resold. If it is blank or says anything other than bosch you are wasting your time.
Good luck!
 
I've had the opposite experience. The unrebuilt original ones have given me no problems, whereby a rebuilt one had water leak into it and kill it. I will only use an unopened AMM
 
Now I have two oem, but both measure little different, so that's why I?m looking for some proper solution...
 
I bet that it is just another chinese sh** with hot film instead of hot wire.
https://www.aipelectronics.com/index.php/catalog/product/gallery/image/1805/id/633/
633
 
You must log in or register to reply here.
Back
Top