• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

Are there any Poly Bushings for the 960?

Greg Wong said:
I have tried to put the "window weld" in the bushing with no luck. I haven't heard of anyone else who did it successfully either.
Click to expand...

Well, now you did.

I've been told to put new bushing in the dishwasher before attempting anything with the windshield urethane.

Worked all right.

There is some bushings here, but it's stupidly expensive.

http://www.retroturbo.com/?product_cat=pubusehs

There is also a few here:

http://www.kgtrimning.org/superpro-bussning/volvo/700900/
 
Last edited:
well they are really a set of ballistic joints found here


https://www.ballisticfabrication.co...ries/products/2-63-heavy-duty-ballistic-joint




i still have not had the time to mock it up in a car as the Project has been standing still for very long time


but it's moving finally and have a new interior coming in aswell as a full wiring from an s80 so .. eventually


Moon_walk said:
i may have a solution for this .. it's in the works and not yet ready . does ned some cutting and welding but will solve this issue once and for all this is what it looks like

a spherical bearing with a polyreutan liner that is replacable and can be tightened aswell fully rebuildable

what needs to be done is to cut off the two cones that hold the arm in Place today

add a weldnut to the bracked and add a reinforcement washer to the brace when the ocne is removed

after this it's all bolt on

DSC_0004.JPG


and this is what it looks

DSC_0319.jpg
Click to expand...
 
You must log in or register to reply here.
Back
Top