home register FAQ memberlist calendar

Go Back   Turbobricks Forums > Mechanical > performance & modifications

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 12-26-2018, 03:05 PM   #1
105Charlie
Board Member
 
Join Date: Jan 2018
Default B200FT turbo swap now cuts out after throttle?

Hi

I've just swapped from the 13g to a 15g on my b200ft (in a 343). Running LH2.4, standard chips and injectors but a 012MAF and 2.5in DP/1BAR actuator. Idles and revs perfect throughout the rev range but dies after any sort of boost or hard throttle usage under load. Seems to bog quite a bit and obviously can only be driven gently at the moment.

Are there any obvious reasons for this before I start checking the loom for damage? I have the original MAF but it won't fit easily with the new pipe setup (a lot less space in a 343). I also have a set of 470cc injectors that I could try if it could be fuel starvation?

Was running perfectly fine running 14psi before I did the swap and tidied up the loom. Any obvious ideas?

Cheers
105Charlie is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -4. The time now is 06:35 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.