• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

15G locator pin removal

pylepants

Member
Joined
Sep 20, 2011
Location
Painesville, Ohio
Hey all, I'm ready to put this 15G on my redblock. I need to get this locator pin out of the cold side though. Looking for some advice before i throw the torch on it. I know you guys know somethin I dont. So, lets hear it.

Thanks,
Matt
 
Oh Ive been pulling. It doesnt want to come out. Thats why Im here. Just wasnt sure if you guys knew a trick. I may end up grinding it down like broke4speed said
 
I usually grind them down.

Death wheel and be done with it.

image_21332.jpg
 
Pulling I had best luck with dikes you know wire cutters. I've also cut them with cut off wheel on die grinder, air powered or letric. Fencing tool probabbsly would work best to grab em and pull. I got one of those now, i'll try that next time.

THey are real hard metal so hard to grab them that's why dikes grab the best! Just try not to damage the aluminum they are sunk into but the surface the hole is in isn't the seal it's that inner edge more important not to ding.
 
Back
Top