amgvr4
New member
- Joined
- Nov 29, 2008
I have read through the entire thread, and I have yet to find an answer to one set of questions. When using the factory fan control wire from a 9xx ecu how are people tying into them? Are they running new wires all the way back to the ecu plug and directly splicing them into ecu pin #7 and #22, or using vampire clips? Is there a spot closer in the engine bay the wires from pin #7 and #22 go to? And finialy is there a place I can find the wiring schematic for my '91 945 so that I can truly verify that pins #7 and #22 are for the fan control? Thanks, if I can figure this little detail out the install will be a snap.