posted pics in my car thread, see the last post
http://forums.turbobricks.com/showthread.php?p=3952632#post3952632
Looks good. Works well?
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
posted pics in my car thread, see the last post
http://forums.turbobricks.com/showthread.php?p=3952632#post3952632
was the general assumption on the 960 cops? Im assuming that these could be used with 960 ignitor module ?
any externally ignited COPS will work fine, just wire them in series.
I have tried the 4/5/6 cyl cops/ws thing, they are too short for the 16v head.
as for using the yota cops, they might work still with an external ignitor wired in parallel, unsure on that. there's no way to wire the trigger signal from the EZK to the cops without keeping the output voltage from dropping (unless perhaps you use a 12v transistor on the buchka board, if possible, that would then send 2 6v signals to the yota cops to fire).
I forget if nathaninwa is using COPS, he just might. he then might also be using the external ignitor with them.