tomasss
former PRVert
- Joined
- Oct 13, 2008
- Location
- Sydney, Australia
Progress with the large 960 throttle body today.
Initially I was following >this< thread but then I had to combine the parts even more because of fitting the TPS.
To summarize it:
From B204FT this is used:
- TPS
- throttle shaft + throttle plate screws
- linkage lever
From 960 this is used:
- throttle body
- throttle plate
- throttle body gasket
Plus there is extra drilling/tapping required into the 960 throttle body as there are no holes for the TPS.
Size comparison
Tapping the 960 throttle body (M4 thread)
B204 TPS mounted into 960 TB
Enlarging the B204 gasket
And finally mounted on the intake
Initially I was following >this< thread but then I had to combine the parts even more because of fitting the TPS.
To summarize it:
From B204FT this is used:
- TPS
- throttle shaft + throttle plate screws
- linkage lever
From 960 this is used:
- throttle body
- throttle plate
- throttle body gasket
Plus there is extra drilling/tapping required into the 960 throttle body as there are no holes for the TPS.
Size comparison
Tapping the 960 throttle body (M4 thread)
B204 TPS mounted into 960 TB
Enlarging the B204 gasket
And finally mounted on the intake
Last edited: