• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

740 Oil/temp wiring on engine swap

1

105Charlie

New member
Joined
Jan 21, 2018
Hi,

So I've finished wiring my BF230T LH2.4 in my little 343 however, I have realised I have no gauges.

Can I run the wire straight from the oil/temp sensors and run them straight to the dash or does it run through the ECUs in some way?

Thanks
 
The oil pressure gauge and water temp gauge wires do not go into the ECU.

So yes, you can run a wire from your oil pressure sender to your oil pressure gauge as well as from the water temp sender to the gauge. Note that there are two water temp senders on the B230xx cyl head. One is for the ECU and one is for the gauge. The one for the gauge has one spade terminal and is around cyl #2/3.
 
You must log in or register to reply here.
Back
Top