M.H. Yount
Active member
- Joined
- Nov 1, 2008
- Location
- Charlotte, NC
Sorry Sean - question directed at TX240’s set up....
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
Holly 302-1 oil pan and STS machining mounts.
I agree, a little more room would be nice, I talked with Scott about it a little bit. I put in a later model rack and gained a c hair more room now.
Sean
Thx - lots of folks looking at the threads for ideas of how they wanna do the swap - so more data points about who did what can help others. I used a thinner oil pan and lowered my rack a little to let me get the motor a bit lower. And that helped with booster clearance as well.
I?m 3 degrees down in back; pinion 3 degrees up.
...which helps with booster clearance no doubt...
Also, nice Taco, 6spd? And I want your canopy.
Hey! That is one great project man! Love it! Makes me want to start playing with my 242 aswell
ADam
I have booster clearance regardless of +5/-5 degrees
Just trying to point out the lower it is in the back, the more you move away from the booster.
Lookin' good! Share your thinking on a 2-piece vs. 1-piece DS on this one. Lots of people struggle trying to figure out which approach they want to take.
I meant I don't have clearance issues regardless.