• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

ATP Ultimate Wastegate pics

Pfff.. everyone knows that ATP designed that flange only for use with DIN 876.. :roll:
retards...

here you go, thank me later...

341090.jpg
 
http://www.pbase.com/towerymt/atp

:e-shrug:

I'd hit it with a grinder and make clearance for the nut, then just spin it down as you lower the WG housing onto the turbine housing. I don't recall clearance being that bad on mine, but it's been a while since I installed it one time.
 
122813098.jpg


123428174.jpg


I think the long-stud nearest the manifold touched or almost touched the housing, but on mine there was room for the nut. I certainly couldn't remove that nut with the WG housing pressed against the turbine housing. But I never need to.
 
I ground the flange. Also have some of those nuts that tryingbe mentioned waiting in the mailbox today.

It's really tight on mine for some reason, beats me.
 
You must log in or register to reply here.
Back
Top