• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

Search results

  1. W

    Clean carbon from pistons

    Compressor air works well and you wipe cylinders down. No issues.
  2. W

    Clean carbon from pistons

    Wire brush on drill.
  3. W

    240 driveshaft front section differences

    M46 shaft is approximately 18"
  4. W

    Replacement interior door panels

    Yeah vpautoparts. $150 a pair. Stock style.
  5. W

    A NEW source for for rear window louvers!

    Pretty sure this is the guy that makes all the RBS parts. So it would still be fiberglass.
  6. W

    TD04 13c bearing housing compatibility with TD04HL turbine shafts

    19t turbo...
  7. W

    TD04 13c bearing housing compatibility with TD04HL turbine shafts

    No. Same issue. 19/20t have larger space for compressor wheel. If you want a 19t you can buy a chinabay turbo for $300. Tons of people run them with no issue.
  8. W

    Headlight Swap

    You can also use 'tv screen' headlights but much harder to find and a lot more $$$
  9. W

    TD04 13c bearing housing compatibility with TD04HL turbine shafts

    No, the compressor wheel doesn't fit. The turbine wheel does.
  10. W

    What to adjust cam gear to with B cam?

    Time it straight up and then gradually adjust 2 degrees + or 2 degrees -
  11. W

    Replacement carpet foam for a 240

    If you want to insulate first and then you can use jute pad. Cut it to size.
  12. W

    Early model 240 AC Conversion

    The stock 91-93 ac condenser fan fits with no issue. I have one available if you decide to go that route.
  13. W

    I keep flushing and flushing but the crap won't go away.

    If it has that much crud, someone else was just running water for a long time. I've run water temporarily and usually 3 flushes gets it clear enough.
  14. W

    Where to get 3" 240 +T Downpipe

    I like to add a flexible pipe on the bottom portion.
  15. W

    Where to get 3" 240 +T Downpipe

    You can buy mandrel bends with expanded pipes. Pipes slip into place. You basically need 2 90 deg bends. Whatever flange you're going to use should be trimmed flat so you can get placement correct. Super easy for 240.
  16. W

    how rare are these aftermarket taillights?

    They are made in Estonia so good 5-10 years. Pricey but got to pay to play.
  17. W

    1981 244 GL High MPG - daughter's first car

    You can currently get the right side headlight bezel...
  18. W

    240 good strut mounts for front ?

    kyb mounts are the go to. Last a good while. You can get them on rockauto.
  19. W

    Bosch 940 turbo distributor cap prices are around 100.00! Are any of the aftermarket caps any good?

    Yeah $20 for cap. $11 for rotor. I would still get Bosch rotor. Had good luck with standard motor caps, obviously won't last like a Bosch cap.
  20. W

    Glass Headlights USDM

    Back in the day, you could buy glass headlights made in Brazil. The truck version is glass but I don't know if they would of been classified as an e-code. It was a cheap way to get glass headlights but as usual, someone caught wind of it.
Back
Top