Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
Hello Guest, welcome to the initial stages of our new platform! You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Hi. Some time ago you talked about adjusting the AW governor to lower your shift points (rpm). I have considered doing the same thing.
Were you able to remove/add springs/weight to adjust your shift points to where you wanted?
the R154 trans is junk honestly and I doubt you will find a clutch that will work very well with it.. I suggest you go with the lighest weight clutch disk you can find because the syncronisers are very weak in the r154.. other than that the clutch I was running was just a spec super twin
So u had good luck with Spec? With my old 11 sec Z28 I had bad luck with Spec. That was also back in 04 so I assume they gotten better with time. What clutch model was it? Reason I ask if I dump 2k plus I dont want a clutch that wont last longer then 10k miles.
Hello, i got a question. When you were running a 2JZ/R154 in your 240 what clutch were you running? My 2JZ in my Cressida should push close to 600rwhp, and need a clutch to handle D/D, strip use.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.