Turbobricks Forums

Turbobricks Forums (https://forums.turbobricks.com/index.php)
-   performance & modifications (https://forums.turbobricks.com/forumdisplay.php?f=13)
-   -   850 manual swap (https://forums.turbobricks.com/showthread.php?t=359779)

Sketchysedan 04-02-2021 12:09 AM

850 manual swap
 
Just bought a 95 850 t-5r, and decided it needed to be manual. Bought an m56 swap off an indie/used Volvo parts shop, they said it would fit and was from an n/a s70. It has a dual mass flywheel. Were the flywheel and clutch diameters the same between s70 n/a, glt, and t5 models? Which clutch should I get that will fit? Planning on keeping the car stock as far as power goes. They did give me the clutch from the n/a s70, it has plenty of life left on it. Would the n/a clutch and pressure plate work or would it slip? Thanks in advance.

Jack 04-02-2021 01:58 AM

That’s a lot of questions

Yes if I remember right

One that fcp sells

Used clutch - toss it in the trash.

Depends how you drive - likely



All of this has been covered extensively on sites like volvospeed years ago

blkaplan 04-02-2021 01:19 PM

buy a single mass flywheel,
Buy a 850R (240mm) clutch kit

Chuck W 04-06-2021 01:25 PM

I don't have the info in front of me, but you're going to run into a speed sensor difference using that newer (98+) trans in the -96 car.

One pulls the speedo info from the ABS system and the other has it on the trans itself.

(I want to say the later cars use the signal from the ABS system)

My swap was a '96 trans into a '97 car, so I had no issues.


All times are GMT -4. The time now is 05:19 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2021, vBulletin Solutions Inc.