Turbobricks Forums

Turbobricks Forums (https://forums.turbobricks.com/index.php)
-   performance & modifications (https://forums.turbobricks.com/forumdisplay.php?f=13)
-   -   bosch to megasquirt tach input (https://forums.turbobricks.com/showthread.php?t=359796)

TimS 04-03-2021 01:37 PM

bosch to megasquirt tach input
 
I'm trying to put a MS2 on a 1984 240 kjet turbo, IC, but don't want to get into ignition control( right now). Can I just go right from the coil or do i tap into the trigger wires from the dist.?
If I use the wires from the dist. do I just tap into each wire and back to the computer
at VR1 and Vr2, with it still connected to the bosch black box?

Tim

bobxyz 04-03-2021 01:52 PM

Normally, for fuel-only, you tap off the coil negative "-" tab. You need to build the MS2 Coil Negative circuits.

I don't know how Bosch Breakerless connects the 2 VR signals from the distributor. If it grounds one of the signals, you might be able to tap off the other VR wire to MS. (MS expects one of the 2 VR wires to be grounded.)

TimS 04-03-2021 07:34 PM

it is actually a microsquirt, so its ready for both. The manual says the same thing about the - side of the coil, but i mentions not to do if its a CDI unit. I'm not sure if that's the same as what a Bosch system is. I was hoping someone would say that they've run MS like that.

bobxyz 04-04-2021 10:25 PM

MicroSquirt is easy - connect the Opto +/- wires to the 2 tabs on the coil -/+ (they cross Opto+ to - tab).

CDI is the same thing as an add-on MSD red high-voltage multi-spark ignition box, not the factory Bosch Breakerless ignition.

Once you want to go beyond Fuel Only, you'll need a LH2.2 distributor, or will need to modify the Turbo K-Jet distributor to lock down the vacuum and centrifugal advance mechanisms.

Dirty Rick 04-04-2021 11:42 PM

I think You can also trigger the MS off the tach output of the power stage.?


All times are GMT -4. The time now is 01:37 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2021, vBulletin Solutions Inc.