home register FAQ memberlist calendar

Go Back   Turbobricks Forums > Search Forums

Showing results 1 to 7 of 7
Search took 0.00 seconds.
Search: Posts Made By: dalek
Forum: performance & modifications 07-13-2021, 12:20 PM
Replies: 69
Views: 12,218
Posted By dalek
What are you going to do about its exhaust...

What are you going to do about its exhaust manifold? Is it part of the turbine or you can separate them?
Forum: performance & modifications 07-03-2021, 10:19 AM
Replies: 69
Views: 12,218
Posted By dalek
Just to make sure, the tube going to oil pan is...

Just to make sure, the tube going to oil pan is steel, going in a bit of an angle, and is still above the oil line, right? From the camera angle it is hard for me to see. :oops:
Forum: performance & modifications 06-23-2021, 06:46 AM
Replies: 69
Views: 12,218
Posted By dalek
They are still better than mine. But, the fact...

They are still better than mine. But, the fact you did your welds using one inspires me to actually sit down and put time on the one I have. If nothing else, I can use it to tack pieces together and...
Forum: performance & modifications 06-22-2021, 01:46 PM
Replies: 69
Views: 12,218
Posted By dalek
Tig/mig/arc?

Tig/mig/arc?
Forum: performance & modifications 06-14-2021, 04:43 PM
Replies: 69
Views: 12,218
Posted By dalek
I do like your angled compression turbine clamp;...

I do like your angled compression turbine clamp; where did you get it?

BMW has some little air-water intercoolers. They may fit between the compressor outlet of one turbo and the inlet for the...
Forum: performance & modifications 06-13-2021, 07:59 AM
Replies: 69
Views: 12,218
Posted By dalek
To get around 30psi at 300rpm you need a pressure...

To get around 30psi at 300rpm you need a pressure ratio of more than 3.18 (assuming volume efficiency of 84%), assuming you are aiming at 190HP (~275CFM/20.9lb/min/570Kg/h of air) at that RPM (the...
Forum: performance & modifications 06-04-2021, 05:12 PM
Replies: 69
Views: 12,218
Posted By dalek
I do need to learn how to weld...

I do need to learn how to weld...
Showing results 1 to 7 of 7

 
Forum Jump

All times are GMT -4. The time now is 03:06 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2021, vBulletin Solutions Inc.