home register FAQ memberlist calendar

Go Back   Turbobricks Forums > Search Forums

Showing results 1 to 6 of 6
Search took 0.00 seconds.
Search: Posts Made By: GTJordan
Forum: maintenance & nonperformance 09-16-2022, 05:48 PM
Replies: 26
Views: 4,734
Posted By GTJordan
I have a punch that I've bent at about a 45...

I have a punch that I've bent at about a 45 degree angle that can be inserted in the unthreaded hole, then the punch hit with a hammer to pop it out. Some can be a real pain. The front one will...
Forum: maintenance & nonperformance 09-15-2022, 08:21 PM
Replies: 26
Views: 4,734
Posted By GTJordan
Which shaft? The prop shaft has to be...

Which shaft?

The prop shaft has to be taken out of the pinions on both ends. You can't leave one in. I remove it completely when I'm at work.

You can't remove a front axle and drive it. ...
Forum: maintenance & nonperformance 09-13-2022, 06:22 PM
Replies: 26
Views: 4,734
Posted By GTJordan
A vibration under load, is almost guaranteed to...

A vibration under load, is almost guaranteed to not be a road force issue. A good road force balance is not cheap either, specially if you have to start swapping tires on rims. I start at 2.0 hrs...
Forum: maintenance & nonperformance 09-12-2022, 05:19 PM
Replies: 26
Views: 4,734
Posted By GTJordan
Anything when decelerating? Only does it...

Anything when decelerating?

Only does it under load?

I'm going to assume everything suspension is tight, control arm bushings are in good shape, upper spring seats aren't torn. That sort of...
Forum: maintenance & nonperformance 07-07-2021, 01:39 PM
Replies: 26
Views: 4,734
Posted By GTJordan
No the rotation is normal. You need to lift the...

No the rotation is normal. You need to lift the front wheel off the ground. Support the car but let the suspension dangle.

Grab the wheel side to side and now shake quickly. Does it knock back and...
Forum: maintenance & nonperformance 07-06-2021, 07:52 PM
Replies: 26
Views: 4,734
Posted By GTJordan
If everything is tight in the suspension (tie...

If everything is tight in the suspension (tie rods and ball joints- use a pry bar and pry down on the control arm between arm and spindle to check for play), then likely axles. I've also had a rumble...
Showing results 1 to 6 of 6

 
Forum Jump

All times are GMT -4. The time now is 04:26 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2022, vBulletin Solutions Inc.