View Single Post
Old 04-27-2009, 10:33 PM   #180
John V, outside agitator
Board Member
John V, outside agitator's Avatar
Join Date: Mar 2005
Location: Sleezattle, WA, USA

Originally Posted by MrSteve View Post
NEWS FLASH: Shipped back to Outside Alligator this afternoon, USPS priority insured.

I was able to straighten the 7mm bit enough to finish my block. I am not 100% sure that my spot facing operation left the squirter pads perpendicular to the drilled/tapped holes. It would be great if the same main bearing cap fixture used to drill the holes could also guide a spot face bit.
But but but but (motorboat imitation) the spot facer thang is piloted with the 1/4" pilot.

Or has that gone missing or broken?

Just what sort of savages are you?

(thanks for returning it)(smooochies)
John Vanlandingham/JVAB Imports
Sleezattle WA, USA

--> CALL (206) 431-9696<----

Vive le Prole-le-ralliat

"When a man tells you that he got rich through hard work, ask him: 'Whose?'"
Don Marquis
John V, outside agitator is offline   Reply With Quote