View Single Post
Old 02-27-2021, 11:32 PM   #9
Board Member
Join Date: Nov 2016
Location: Whidbey Island, WA

Sounds good, I will give it a shot.

So I managed to make some headway removing material very carefully with an angle grinder and a belt sander, its pretty close and will probably finish with a file taking my time. I did manage to snap off one of the studs 3/16 below the surface and proceeded to make matters worse by trying to weld a nut onto it, which I have successfully done many times. This time just didnt go as planned, itll take me a while to get it out.
Sliding242 is offline   Reply With Quote