FreeEMSFred
New member
- Joined
- Nov 2, 2009
- Location
- Kiwiland
The factory bushings in my early solid axle 960 torque rods are flogged enough to move quite a lot and cause some driveshaft vibration in 1st gear under load (only). I see IPD does OEM and aftermarket similar - are there stiffer/better options available commercially? I couldn't find any. I could get some made up but thought I'd ask around first.
What about rotating them 90 degrees? Or putting fresh ones in 90 degrees rotated? Bad idea? Common practice? Other?
Cheers!
What about rotating them 90 degrees? Or putting fresh ones in 90 degrees rotated? Bad idea? Common practice? Other?
Cheers!