View Single Post
Old 10-27-2018, 08:02 PM   #23
lummert
Board Member
 
lummert's Avatar
 
Join Date: Jan 2008
Location: Portland IN
Default

Quote:
Originally Posted by lummert View Post
I pressure tested the four Bosch 0 280 150 934 injectors that I was previously running at 20 psi. Two of the four leaked down within 5 minutes.
Tested the 2 spare 0 280 150 934 injectors. They passed, so I now have 4 good injectors out of 6.

Now the big question...Do I keep running the GEN III 0 280 155 811 White-top injectors flowing 346.89 cc/min @ 2.5 Bar (380.0 cc/min @ 3 Bar) or do I swap back to the 0 280 150 934 white-top injectors flowing 315 cc/min @ 3 Bar (300.1 cc/min @2.5 Bar)? The LH 2.2 AMM has to be adjusted quite low for the higher flow 0 280 155 811 injectors, even at 2.5 Bar. The 0 280 150 934 injectors work just fine on LH 2.2 at 3 Bar.

Minimum pressure for Bosch GEN III injectors is 30 psi (2.0689 Bar), Maximum is 100 psi 6.8964 Bar.
__________________
Trying to understand stupid people is like trying to pick up a turd by the clean end.
lummert is offline   Reply With Quote