View Single Post
Old 02-06-2021, 02:47 AM   #182
DavePolyakov
Board Member
 
Join Date: Aug 2020
Location: Shoreline, WA
Default

Here it is. 4-cylinder dampened slip yoke with a shortened front shaft that is 16.5 inches front U-Joint center on the yoke to the middle of the Spicer bearing. It was raining all day today, I need to get longer bolts then I will install it tomorrow and upload a photo. Tasca messed up my first order for a rubber block that I need to install the clutch cable to the pedal and it's coming in a few weeks so I think I'll have to wait until then before I can drive it. It's confusing a 45mm or 1.771 inch ID bearing fits the two-inch shaft

Quote:
Originally Posted by VB242 View Post
Any word on how this turned out?
DavePolyakov is offline   Reply With Quote