View Single Post
Old 02-08-2021, 06:08 PM   #192
DavePolyakov
Board Member
 
Join Date: Aug 2020
Location: Shoreline, WA
Default

It looks like your yoke is almost flush with the fin with the three bolt holes whereas mine is flush with the tail shaft. That's probably closer to a 1.5-2.0 inch difference. Also, because mine is a two-piece setup my yoke doesn't even move in or out at all during driving. It should be in at least 3/4 if not a little further because it's not ever going to bottom out. I'll probably end up going back to NW drivelines sometime this week.
Quote:
Originally Posted by carver View Post
Here's mine... 3/4" out the back.



Thinking you might want to get that looked at, not much engagement on your setup. Measure 20 times cut once....

Yeah that sucks, I'm out about that much for everything with my custom aluminum 3" one piece setup with the monster yoke, including balance.
DavePolyakov is offline   Reply With Quote