View Single Post
Old 11-25-2020, 10:41 PM   #2
Dirty Rick
Board Member
Dirty Rick's Avatar
Join Date: Apr 2013
Location: Cornholio, OR

If you don't have a lot of compression E85 doesnt want to fire on a stone cold motor.
A blast of spray cleaner will help get it fired for setup.

You are likely good at 6 on the reqFuel, if the reqFuel gets too big you will loose granularity at the low end of the table.
If the low end of the table gets too small, reduce the reqFuel.
Make this decision early on as changing the reqFuel affects all areas of the VE table.
Changing the reqFuel means the entire VE table will need to be re-set.
I don't know who I am when I am somebody else.

Last edited by Dirty Rick; 11-25-2020 at 11:06 PM..
Dirty Rick is offline   Reply With Quote