volvoboy67
Board Member
- Joined
- May 6, 2007
- Location
- Kansas City, MO
Looking really good, man! Can't wait to see things start going back in!
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
I'd buy an HG set from the dealer. The elring HG and exhaust manifold gaskets are not as nice....
Meh, It'll be fine.
I'd do a S60R MLS gasket before I spent money on the reg HG at the dealer.
(And I don't think they sell an HG set anyway)
I'd steer clear of those URO 274111 motor mounts for your application... They are just OK on a stock 240, but on anything making over say 100hp I wouldn't bother with them. Sure they're super cheap, but swapping mounts sucks.
The stock engine mount configuration in a 240 is more than slightly retarded.
https://lh3.googleusercontent.com/_7EUAij74Ycw/R4RTLtHYRnI/AAAAAAAAGuM/65V0P9GX-Sw/s640/DSC01035.JPG