View Single Post
Old 04-27-2009, 05:24 PM   #178
SteveMD's Avatar
Join Date: Feb 2004
Location: Stop paddling, I hear banjos.

NEWS FLASH: Shipped back to Outside Alligator this afternoon, USPS priority insured.

I was able to straighten the 7mm bit enough to finish my block. I am not 100% sure that my spot facing operation left the squirter pads perpendicular to the drilled/tapped holes. It would be great if the same main bearing cap fixture used to drill the holes could also guide a spot face bit.
SteveMD is offline   Reply With Quote