View Single Post
Old 04-25-2021, 01:39 PM   #2
Board Member
Join Date: Mar 2013
Location: Florida

Originally Posted by Johnnya101 View Post
I have a 1991 245 that has the factory hood and factory mercury hood light, however there is no wire going to it. I am quite puzzled. There is no green wire floating around the engine either. Would anyone with a late 240 be able to post photos or at least describe where the wire starts so I can see where it is or where it was cut?

Side question: what is this red wire for? It is very short.

The red wire is a jumper location to trigger your starter motor for diagnostic purposes,

Plug in a wire and tap to +12v on the battery and itll kick over the motor, ignition on the car will start

Good luck with your light
---1991 volvo 745 turbo wagon
**m47 swap incoming !

--1977 244 360k+ miles all original
** drive till wheels fall off
whatshouldido is offline   Reply With Quote