View Single Post
Old 07-22-2021, 12:14 AM   #2
culberro
Ronald Culberbone III
 
culberro's Avatar
 
Join Date: Feb 2010
Location: Portland, OR
Default

The valve guide diameter is 13.5mm, so you’ll want an ID on the washer that’s slightly bigger than that. Shim the spring so it’s within 1-1.5mm of coil bind at full lift.

When you use valve spring shims, make sure the smooth edges are towards the aluminum, and the sharp edges towards the spring seat. Better yet, debur the sharp edges.
__________________
Cult Person. Pissing in your Kool-Aid.
culberro is offline   Reply With Quote