View Single Post
Old 12-31-2020, 12:52 PM   #3
kyote
Living The Dream
 
kyote's Avatar
 
Join Date: Apr 2003
Location: La Porte TX
Default

Quote:
Originally Posted by bobxyz View Post
ALED (aka D16) is driven by a generic 3904 NPN transistor (Q8), $0.05 plus shipping. How do you have the relay wired? LED pin to one side of the relay coil, and the other side of the relay coil to switched +12V?

Before taking anything apart, I'd try the I/O Test Modes menu in Tuner Studio and see if turning on and off LED D16 lights up the ALED and/or runs the fan. Depending on where the fan relay is getting power, you might need to enable the fuel pump relay first.

edit: nevermind, you're talking MicroSquirt, not MegaSquirt. MicroSquirt drives the ALED pin with a 3NV04D mosfet driver - 8pin surface mount chip. It might be replaceable by someone with surface mount rework equipment. I'd check the wiring first.
Wiring good, if I ground the wire headed to microsquirt fan comes on.
No way I can do surface mount, hands too shaky, but surely someone can
__________________
-78 242 tic, a kyotefab/willettrun joint
-83 245 tic, daily in progress
-14 F150 FX4 3.5 EcoBeast (Wife's)
kyote is offline   Reply With Quote