View Single Post
Old 06-27-2021, 09:25 PM   #171
DD Ranch
Board Member
DD Ranch's Avatar
Join Date: Oct 2010
Location: Tampa Bay, FL

Originally Posted by volvowagoon View Post

That's exactly it! No compressor needed. Keepin mind you'll want to drop both at the same time so that you aren't fighting the sway bar. Before you drop the struts, mark where the banana washers is in relation to the towers so that your camber remains close after you bolt everything back together. Then if you drop the struts down as far as you can and pull them all the way to the outside, you can finagle the plate in from the engine side. The hardest part is keeping the top of the mount from spinning while you try to get the plate on all three studs.
Great! Thank you for the explanation. I need to tackle this on the grey wagon.
Florida Chapter VCOA
DD Ranch is offline   Reply With Quote