sUbZeRo_DE
New member
- Joined
- Jan 20, 2021
- Location
- Griesheim, Germany
Hey guys,
i have a serious Problem,
i am running an B230FB with an 951 ECU basically with the head shaved 1,5mm, H cam, and 315cc Bosch EV6 Injectors. I cant get my Head around Programming... The car has a Wideband installed and i burned a lot of EEPROMs but none seems to work... Idle and low Load is pig rich, WoT is m?h...
I tried several things:
Tinkering with Inj Const#4 to 2443, gives such low load, that WoT Lambda shutoff does not engage
Setting Inj Const #1 to the appropriate Value gives some good WoT Values, and Lambda Shutoff is working
BUT
on both Setups, Idle is Rich as f**k 10:1 or so, warm start does not work, too much Fuel
Rough running in low load, bad idle
I tried compentsating with the temp enrich afterstart, cranking values etc but nothing seems to work...
Sadly i do not have an Ostrich... I also tried klr142?s map he posted, but that does not to work also....
The car was fitted with an Cold Start Valve, which is gone now, because i used the Inlet Manifold of the FB Engine, which does not have the port for that, and i noticed that after 20 hours of porting the Manifold.... But that should not be an issue.
Exhaust Manifold is still Stock, witch stock downpipe, a 200cpsi Cat and 2,5" Catback exhaust.
I am just smashing my head, any advice is highly appreiciated.
Greetings from DE =)
i have a serious Problem,
i am running an B230FB with an 951 ECU basically with the head shaved 1,5mm, H cam, and 315cc Bosch EV6 Injectors. I cant get my Head around Programming... The car has a Wideband installed and i burned a lot of EEPROMs but none seems to work... Idle and low Load is pig rich, WoT is m?h...
I tried several things:
Tinkering with Inj Const#4 to 2443, gives such low load, that WoT Lambda shutoff does not engage
Setting Inj Const #1 to the appropriate Value gives some good WoT Values, and Lambda Shutoff is working
BUT
on both Setups, Idle is Rich as f**k 10:1 or so, warm start does not work, too much Fuel
Rough running in low load, bad idle
I tried compentsating with the temp enrich afterstart, cranking values etc but nothing seems to work...
Sadly i do not have an Ostrich... I also tried klr142?s map he posted, but that does not to work also....
The car was fitted with an Cold Start Valve, which is gone now, because i used the Inlet Manifold of the FB Engine, which does not have the port for that, and i noticed that after 20 hours of porting the Manifold.... But that should not be an issue.
Exhaust Manifold is still Stock, witch stock downpipe, a 200cpsi Cat and 2,5" Catback exhaust.
I am just smashing my head, any advice is highly appreiciated.
Greetings from DE =)
Last edited: