If you can get an 8-bolt flat flywheel core, STS machining/77volvo245 or Ben kaplan (Kaplhenke racing) can drill it in the OE LH2.4/EZK pattern, or if you have an indexing head lathe or similar and want to live dangerously/try your hand at it/balance at your own risk/figure it out?
Or degree wheel and a drill press/drill fixture...uh..of some kind?
A couple suppliers have done steel flywheel runs in low volume as well, bring your own starter ring gear...
__________________
How PSI a stock can support?
Always Be Crushing!
Quote:
Originally Posted by JohnMc
If you send me $20$14.99, I'll send you a how-to explaining how to make $20$14.99 from people on the internet.
|
|