View Single Post
Old 12-02-2021, 09:07 PM   #18
Kjets On a Plane
Board Member
 
Kjets On a Plane's Avatar
 
Join Date: Nov 2002
Location: Californicated Oregone
Default

^If the trans mount is oil soaked bouncy jell-o or there's oil all over the tunnel from a leaky engine or trans tailshaft bushing....
...or someone didn't reinstall the bullet connector back in the clip on the trans.

But the hot weather cars and rotting wire insulation also doesn't help much, nor windshield leaks/cabin moisture for the electrical or solder joint issues on the relay or hot salt air florida or atlanta climate.

I've seen the fluid passage blocked in the trans from some numb-skull not putting on the mask/glasses or face shield and respirator and blowing the debris out from around the solenoid and scrubbing it clean around it prior to removal and allowing debris to fall in the upward facing holes...
__________________
How PSI a stock can support?
Always Be Crushing!

Quote:
Originally Posted by JohnMc View Post
If you send me $20$14.99, I'll send you a how-to explaining how to make $20$14.99 from people on the internet.
Kjets On a Plane is offline   Reply With Quote