Lord Tentacle
Anime Lord
- Joined
- Aug 6, 2005
- Location
- Sydney, AUS/Appleton, WI
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
I need custom axle's anyways because of the need for 5x112 stud pattern and the very custom width
I'm doing the tube shortening myself has I have the lathe and other tools needed to do it properly
Built 9" is >$7k here in aus
I'm looking at sub $2k for the Dana 70 (over and done with)
I would think if it were shipped it?s pieces, or in a container, a 9? could get to you for much more reasonable price.
Shipping to OZstralier is no joke.
I have shipped all over the world, it?s not that hard to save a bit of you do it right.