home register FAQ memberlist calendar

Go Back   Turbobricks Forums > Mechanical > maintenance & nonperformance

Reply
 
Thread Tools Display Modes
Old 09-21-2022, 04:25 PM   #101
TheMenaceSD
Board Member
 
Join Date: Mar 2016
Location: Escondido, CA
Default

Yea, I've found them just need to wait till I get paid. Since this is a project car and not my daily I have funds set aside each check for parts and such. Last check was gone with fluids and other replacement parts. Just need to wait till the next round and grab the gasket.
TheMenaceSD is offline   Reply With Quote
Old 09-23-2022, 01:34 PM   #102
TheMenaceSD
Board Member
 
Join Date: Mar 2016
Location: Escondido, CA
Default

New head gasket it on, will start the reassembly and checking valve clearance.
TheMenaceSD is offline   Reply With Quote
Old 09-23-2022, 05:00 PM   #103
TheMenaceSD
Board Member
 
Join Date: Mar 2016
Location: Escondido, CA
Default

Quick question regarding the guide pin on the camshaft. Is it supposed to need a hammer or mallet to install or should you be able to push it in by hand?
TheMenaceSD is offline   Reply With Quote
Old 09-23-2022, 05:10 PM   #104
white855T
Board Member
 
Join Date: Sep 2013
Location: Dallas,TX
Default

You have to tap it in. Did you get the ipd pin?
white855T is online now   Reply With Quote
Old 09-23-2022, 05:25 PM   #105
TheMenaceSD
Board Member
 
Join Date: Mar 2016
Location: Escondido, CA
Default

I did, but I didn't have to tap it in. I was able to just press the pin in by hand without much resistance.
TheMenaceSD is offline   Reply With Quote
Old 09-26-2022, 01:25 PM   #106
TheMenaceSD
Board Member
 
Join Date: Mar 2016
Location: Escondido, CA
Default

Small update, I measured the valve clearance and needed to order a couple shims that I didn't have. When I get back from vacation I will have everything ready to finalize the build and check to see if it starts.
TheMenaceSD is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -4. The time now is 03:36 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2022, vBulletin Solutions Inc.