• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

Where to get this part

Q

QisofrKuin

Member
Joined
Feb 19, 2021
Location
Dallas, TX
Hey everyone,

Been searching around for a while but can't seem to find the correct name to get a hit on this part, the rubber boot between the throttle and the air flow sensor, I think. Here it is on a European website, but wondered if they are sold anywhere in the states?
https://www.skandix.de/en/spare-par...intake-collector-flow-divider-rubber/1012350/

It's marked as #24 on this diagram:
https://www.240turbo.com/CI_Injection_TP11121_1976me.jpg

Mine is old and cracked and giving me a massive vacuum leak.
Thanks.
 
Be careful not to stretch or fold to sharply. These things can tear or crack easily. Put the big end on first and then just squish it down a little to get the top on.
 
Check the condition of the air flow housing rubber mounts as well. I couldn't figure out why my boot wouldn't go all the way on until I saw those were shot. Actually someone here told me about them, I didn't even know they were there. One of those "while you are in there" things.
 
2turbotoys said:
Check the condition of the air flow housing rubber mounts as well. I couldn't figure out why my boot wouldn't go all the way on until I saw those were shot. Actually someone here told me about them, I didn't even know they were there. One of those "while you are in there" things.
Click to expand...

careful with the hook mounts, one enters sideways and one vertical, i kinda pulled a little hard on the horizontal mount and tore it :(
 
You must log in or register to reply here.
Back
Top